How to apply
Reusable, waterproof eye art — no liquid liner, no smudging. Follow these 6 steps for the cleanest hold and the most wears per design.
1
Prep your skin
Clean, dry, oil-free. Skip heavy moisturizer beforehand.
2
Peel slowly
Lift from one edge with tweezers so the design doesn't fold.
3
Coat with glue
Cover the back in a thin layer. Wait 30 seconds until tacky.
4
Position it
Line it up before it touches skin — it holds fast on contact.
5
Press & hold
Firm pressure, center outward, for a full minute.
6
Store it flat
Back on its backing sheet right after removal. 4–6 wears with care.
Tip: Avoid touching the adhesive — oils reduce stickiness.
Heat and sweat shorten wear time. Press lifting edges back down right away.
See how to remove
How to remove
Removing stickers the right way keeps them reusable for a second, third, even fourth wear.
1
Find an edge
Start at the outer edge with tweezers or a clean nail — never the center.
2
Peel slowly
Low and close to the skin, opposite the direction you applied it.
3
Clean it after
Once it's off, wipe residue with micellar water for an easier next application.
4
Lay it flat
Back on its backing right away. Add a dot of clear glue if it's lost tack.
5
Skip the scrub
Warm water or gentle cleanser is enough for any leftover tackiness.